print-in-place hinge design
Elise Ashley
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
0
0
게시일:2026-03-15 20:01:40
1
0
000설명
모델 소스
리뷰(0)
simple print-in-place hinge to add to other designs
It's so simple to print even I could do it, please post makes! :)
Print Settings
Printer:
Sovol SV01
Rafts:
No
Supports:
Yes
Resolution:
0.16
Infill:
Gyroid 15% (full size), 20% (half size H), 100% (half size V)
Filament:
Sovol PLAWhite
Notes:
Tested both at full (20 mm wide) and half size.
Both vertical and horizontal print tests successful.Sliced with Cura. For the vertical half size I chose an initial layer horizontal expansion of -0.1 mm because my printer over-extrudes slightly causing elephant foot. Chose Gyroid in-fill for better strength.
Original Tinkercad objects:
모델 소스
원본 링크: 자세히 보기
CC-BY