Remix of a remix! The one from Dlernstrom is the right size, but the prongs are very thin. They kept snapping before I could even install the mount.

I used their part as a template and made a new one from scratch in Inventor because I'm garbage at altering mesh objects like STL files. I made the prongs and cross pieces both thicker, and added an extra prong for good measure. I also made the top of the prongs a little longer to make sure it held the deco in firmly and wouldn't slip out if it was bumped.

Note that it's a pretty tight fit when you put the Deco in. If I were less lazy I would make and print another version with a tiny bit more room, but it's sturdy enough that it can handle a little fit of flex as you force it in there.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Filament: Hatchbox PLA Black

Category: Electronics