just a simple holder for activated charcoal pellets.

great for closed smelly areas(shoe closets, fridge)

you can adjust the fill ratio for smaller pellets

g-code is designed to make 2 of them so if you want to make only one, please use the STL files with this setting:

panel

wide flat side as bottom

30~50% infill(depends on charcoal particle size)

no solid layer with horizontal shells settings

2~3 vertical parameters

pin

print vertically

0% infill

no solid layer with horizontal shells settings

1 vertical parameter

base

smooth side as bottom

20~30% infill

at least 4 layers with horizontal shells settings

at least 4 vertical parameters