The body and hanger are printed separately and then put together with a bit of super glue. Optionally you can add the cross bar or basked (which has a built in cross bar). The basket it a good place to store small costume jewelry, wig cap, etc. The crossbars allow for additional hangers (wig hangers or normal hangers) to be chained off of the basket allowing multiple short wigs to be hung in a chain or for a costume to be hung from the wig that it goes with. 

Small supports are built into the ends of the crass bar (both the basket cross bar and the standalone bar) as well as in the end of the hanger, which can easily be broken away. No other supports are required though some slight drooping at the top center of the body is to be expected.

The crossbar or basket can be inserted at a slight angle as shown in one of the pictures and then slid down into place. This must be done BEFORE the hanger is glued in place. 

Pay attention that the “prongs” on the basket are on one of the long upright sections on the body and not the short sections, other wise it will be hard to squeeze into place and the hanger wont align properly when it is added.

One the cross bar or basket has been added to the body (if so desired), then the hanger can be attached and held in place with a bit of super glue inside the forked end and on the flat where the body naturally rests.