I got a little frustrated with the need to constantly reach out to the back of the 3D printer to plug and unplug the USB for the Prusa Mini. As a result, I made a mod based off a few other designs already available to fit my USB extension cord.

Print instructions

Printed on eSUN PETG with 240 degrees Celcius for all layers including 1st layer.
Be sure to gently pry open the knob on the screen using a tool to act as a lever
Evenly tighten the screws holding the cover to the PCB board, I noticed it is possible to warp the board if tightened incorrectly
The cable bought was the 20cm USB 3.0 Up Angle 90 Degree Extension Cable Male To Female Adapter Cord USB Cables.

Cable Purchase link: https://www.aliexpress.com/snapshot/0.html?spm=a2g0s.9042647.0.0.f1fc4c4d9WpcJR&orderId=8011713709026268&productId=33035877540