Hexagonal Dice Tower
anderson2014
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
0
0
게시일:2025-12-14 23:32:58
0
0
000설명
태그
모델 소스
리뷰(0)
I wanted a dice tower that didn't need any support to print properly, so I made my own. It's hexagonal and will fit in place of two tiles on Catan with 1mm of space around it (I don't like snug fits).
Print Settings
Printer:
Sidewinder X1
Rafts:
No
Supports:
No
Resolution:
.28
Infill:
100%
Filament:
Geetech PETGclear
Notes:
The tower needs to be printed upside down so that no support is needed. I printed mine with 100% infill to make the hexagonal connecters just a little more solid but I don't think that it would matter at all if you selected 0% infill. The connectors between the tower and the tray are loose fitting (once again 1mm gap because I don't like a tight fit).
It prints nicely and works well. It's a very simple design but it is tall (250mm height).태그
모델 소스
원본 링크: 자세히 보기
CC-BY