Support bracket for the MK3 with the new Delta PSU. This is used when removing the PSU to make an enclosure for printing things like ABS. (Power supplies don't appreciate the heat like ABS filament does!)

Print instructions

Suggested Settings

Slic3r PE .15 quality with the following modifications:

• 6 perimeters (prevents infill in the large sail support)
• 50% infill (for more rigidity)

Other notes

1. Print it so the hex nut holders are facing up.
2. I didn't need supports, a raft, or anything else.
3. You'll need to replace the PSU upright bolts when attaching this stand with a bolt/nut. I used #8-32 button-head bolts to secure the uprights, but the hole and hex inset should fit metric bolts as well.