UPDATE MAY 15TH 2025:
I've uploaded a fully print-in-place model, no need to print the pieces separately. This one works excellent, but just note that the scrub daddy eyes/mouth portion will be printed horizontally, rather than vertically like when they're separate pieces. It still looks great and works incredibly well, but just note the difference. You can always print at a smaller layer height to adjust for the visible lines.

I've attached a picture of the latest single piece model I printed with .2 layer height in PETG.

Original Description:

This is a mashup of what I feel are the two best scrub daddy holder designs for a divided sink. 

NOTE: THE SEPARATE FACE PIECES ARE THE EXACT SAME AS THE ONES FROM THE SCRUB DADDY V2 SPONGE HOLDER.

Thank you to the original creators of both of them and I hope you like this version!

PRINTING: For print settings on the caddy, I haven't fiddled with position on this much but I usually prefer a 45 degree angle to keep from there being too many supports in places, making it ugly.

For the face pieces, they don't need supports, just print them facing upward.