Summary

This adaptor plate is intended to allow you to remove the exisitng PDW stock and install a standard "AR" buffer tube and butt stock. Improves cheek rest and battery capacity depending on your stock type.

FOR AIRSOFT ONLY.

Does not work with a sling mount as there is simply not enough "meat" on the buffer tube mounting section otherwise there is a risk of snapping.
I have tested this in a game with pretty low quality settings, so if this is printed with 100% infill it should be pretty sturdy.

Make sure that you have a long buffer tube screw to reach all the way down into the gearbox. Professional installation required by an experienced airsoft tech to make sure that the wires and screws go in properly. Some sanding may be required.

Mine was printed in PLA but you can print in any material.