Just a case/mount solution to mount Raspberry Pi Zero 2 to the excellent Prusa Mini Base mod by David Warboss:

https://www.prusaprinters.org/prints/63483-prusa-mini-base

It uses the existing holes in the Mini Base rear right leg, so no modification to the base is necessary, ideal for octopi.

Requires 4 x M2.5 x 6mm screws to secure the top and bottom pieces, I've added 4 M2.5 nuts at the rear, but they're not critical, just dont over tighten. 

Requires 2 x M3 screws to mount to Prusa Mini Base rear right leg, I used M3 x 20 as that's what is recommended to mount the filament sensor to the right front leg to the Mini Base.

Printed in PLA @ 0.15 layer height, but should work fine with most filaments and layer heights.

This is the original case:

https://www.prusaprinters.org/prints/84138-slim-raspberry-pi-zero-2-w-case

I've just made the bottom thicker for greater rigidity as the original bottom was very thin, and I've added screw holes as the existing model didn't seem very secure.