UPDATE: I noticed the Dragonburner was  hitting the screen just slightly when at Y0.  I added a little cutout to prevent that. I haven't printed this one yet as I like K Millers remix and may try that instead. 

Beware: the KNOMI 2 is 5v Only.  You have been warned.  Don't fry it by sending 24v to it. 

I remixed this design to work with the KNOMI 2 screen which is bigger. 

I had to make the hole bigger and change the way it is held in place.

I also made it more symmetrical and added some bulk. 

4x M3x8 BHCS 
4x M3 x 5 x 4 mm heat set insert  (Voron standard)
 

Installs just like the original just insert your heat sets rather than using nuts.  The bar has a cutout for the connector to line things up.