• Can be printed in any material.
• Print it in the original orientation.
• Make sure to place the seem somewhere where it is not visible, i placed it on the inside top, as can also be seen in one of the photos.
• there are two sizes 29 and 39 mm, which is the size of belt they fit.
• If you have a different size belt, either adjust the size in the Z-Axis or just let me know then I can make a model that fits!
• The models goes very nicely with my watch stand model as well. https://www.prusaprinters.org/prints/27759-watch-stand-no-support

Good Luck and Happy Printing!!!

Check my Instagram: fredslund3d