This is a remix of Logitech C270 arm base for 30x30 aluminum extruded profile by Stanley

I made this so I could mount a Logitech C270 to the corner of the heated on my Prusa Mini+.

Printed in PETG at .20mm with a 15% infill. Supports maybe needed around the cable guide clamps.

The camera mount requires a M3x20 screw and a M3 hex nut, each arm requires a M3x16 screw and M3 hex nut, and for the parts that attach to the bed directly you'll need to replace the M3x8 screw with an M3x12 screw.

Finally after you mount your camera be sure to send the heat bed all the way back and the extruder all the way out to verify you have enough clearance.