I designed table numbers that can be used for occasions like weddings. It is easy to print them as multicolored prints even without MMU. The gcode files are prepared for that. 5-10 minutes before the end of the print the filament swap will be requested.

Depending on the tolerances of your printer you may need to add a little dab of glue for the plate to stay attached to the stand.

Sizes:

• Plates: 11 x 15 x 0,31 cm
• Stand: 5 x 5 x 2 cm
• Stand slot: 0,315 cm

For my print I used the following filaments:

• Plate: PLA DasFilament - Tonweiß
• Numbers and stand: magicPLA 3DJake - Frozen Gold