AA Battery Dispenser
Santiago Clements
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
0
0
게시일:2026-04-02 09:25:49
1
0
000설명
태그
모델 소스
리뷰(0)
I needed a way to not only store my batteries but also make sure that they all get rotated through service. I was having one or two batteries at the bottom of my storage case that would not get used and re-charged. This solves the problem for me. I also made a 9 volt version and a AAA version.
Print Settings
Printer:
Artillery X1
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.35
Infill:
15%
Filament:
generic petgorange
Notes:
I print fast and dirty using .35mm height and 1mm width, it seems to work out quite well, but if you prefer to have prettier prints then you could print it however you would like and it should work out fine. No supports are needed as the little mating "pins" that I have created are built on top of an angled base that doesn't need support.
태그
모델 소스
원본 링크: 자세히 보기
CC-BY