filament clip
Seth Montgomery
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
2
2
0
게시일:2026-03-20 08:58:13
5
0
220설명
모델 소스
리뷰(0)
i made this to hold the filament in place to keep from unraveling from the spool.
there are 2 ways to secure the filament:
- is to push the filament into the top slot after tightening the clip to the spool.
- place the filament into the lower slot as you tighten the clip to the spool. this will make sure it is securely tightened in place.
no supports.
- i added a screw with knurling.
Category: 3D Printer Accessories
모델 소스
원본 링크: 자세히 보기
CC-BY