This solder spool holder is designed to fit a Kester 1 pound (454g) spool. It is made from 2 identical parts that mate together (commonly known as a “hermaphroditic” part) and are secured by a single 3/4” or longer 10-32 screw and nut through the center of the spool (smaller hardware either ASE or Metric with washer would also work). I added pockets in the bottom for adhesive back felt disks from Dollar Tree, but 3/4” diameter rubber feet would work as well to limit sliding. I printed both parts at the same time on my Anet A6 using the CraftWare slicer in easy medium mode.

April 1, 2018

See improved design at https://www.thingiverse.com/thing:2821423

Anet A6

No

No

.3 mm

any