A combined AMS riser and light bar in one.

This remix is a pretty big departure from the original, completely new gluing sytem and has been adjusted to suit the newer (?) AMS units with the front feet closer together than the rear.  

My AMS has its rear feet 342mm outside to outside while the front are 334mm outside to outside.  It sits perfectly on top of this frame.  I have cut small feet out of some foam and attached them to the bottom - Don't try to grab extensions from the original remix because the feet length and width also seemed to be different. - UPDATE: at the request of someone here I've added an .stl for printing out tpu feet to fit underneath.

BE CAREFUL when putting the parts together, the thicker section on two of the pieces are 4mm longer than the other two and together form the back.  The two shorter ones are for the front side.  The clips are also in two different sizes.

It should all fit on one build plate if you ignore the warnings about the pieces being too close. 

I've printed mine out of CF PETG and glued it together (using the clips) with superglue.  I print a lot of high temp stuff and my top glass can get pretty toasty.

I used this led strip from jaycar which fit perfectly - just cut it up, tin the connections and wire it up to a 12V 1 amp plug. 

I intend to take the power from the printer itself at some point in the future but that is a project for another day.

EDIT: oh also, I just used my soldering iron to melt a bit of the back edge to slot the incoming power wire into, it isn't part of the model itself.  You'll figure out something similar I'm sure :-)

Cheers,

Dave