This was inspired by the Ranger's Apprentice stories by John Flanagan and the fan discussion here (https://flanagan.fandom.com/wiki/Flanagan_Wiki).  I wanted to keep it simple and safe for those younger apprentices.

There are 3 parts to this model - a left Saxe Knife Scabbard, a right Saxe Knife Scabbard, and a general Throwing Knife Scabbard.  The Saxe Knife Scabbards have hooks that can attach to a belt or waist.  There are also impressions on the opposite side where up to 3 Throwing Knife Scabbards can be glued.  I intended the top of each scabbard to be a "brass" throat to keep with the design of the rest of the Ranger's Apprentice series.

The scabbards are printed vertically on the table to allow for a color change.  Everything is printed at 0.2 mm detail without supports.  I needed to use a 20 mm brim with 0.0 separation gap for the Saxe Knife Scabbard since it liked to fall over.  I used the same type of brim for the Throwing Knife Scabbards but I don't think it was necessary.

The Saxe Knife and Throwing Knife are in separate models.