Summary

If you have this great little drill the lack of rack & pinion table height adjust will have no doubt been an issue when you want to move the table height by a small amount and it slides freely miles away. Or if you want to turn the bed left and right but drill at the same height.

This uses a quick release clamp from eBay for a bicycle seat post and grips the 48mm tube well enough to support the weight of the table to turn it side to side or can be moved a set amount and then the table lowered to it. I used nyloc nuts so tension is set once and stays correct.

Probably best printed in PETG or better, but I printed this in PLA+ and it is fine. Just use enough tension to grip not over stress it. The shoulders are unequal in length as I had a 50mm bolt so that side is a little shorter. The seat post clamp is M6 so both holes are for M6. Printed in the orientation of the 3D photo, flat.