Windchimes Step Clamps.

Step clamps to hold work pieces on a work piece table.
See the photos included.

The horizontal and vertical surfaces on the steps are at a 52 degree angle of each other.
This reduces the risk of the bridge slipping of the stairs.

Printed with:
4 mm wall thickness.
100 % infill.

Print the part with the step pointing UP.

Warning: These Windchimes Step Clamps have not been tested much.

Note:
The clamp is slippery on the work piece.
It helps to put some gaffer tape on the contact side of the bridge.
Like shown in the second photo.
Maybe someone finds a better way to reduce the slipperiness ?

FREECAD FILE INCLUDED.

Anet

A6

Yes

Yes

100

Stick gaffer tape to the point contact surface to reduce slipperiness.