Summary

I love the design of thebrothermurph's Copic marker storage.
However, as I am moving away from Copics as my primary markers to Ohuhu Honolulus, I wanted to make a version of the original design that fits the round markers.

What's the same:

• 10 markers stored per row.
• markers are stored on the side at a slight angle.
• the modular design - just print extra top and bottom sets for a new stack.
• As with the original design, use of rubberized stick-on feet is recommended.

What's different:

• the design is re-imagined for round Ohuhu marker
• rather than the original 4 corner pegs, my design features triangular alignment pegs - the angle of the peg should print without supports or sagging on most printers. When printed as-is, the pegs hold the stack well enough to keep the stack together, however this fit depends on your printer's individual printing tolerances.
• the design features holes for 3x6 mm round magnets which can be glued in to the recesses to hold the stack together. This option is great for those with curious cats.

Considerations:

• Printed using the DRAFT setting, the stack fits together without issue.
• The allowance for markers is pretty tight per personal preference to prevent them from sliding out too easily. If your initial print comes out too tight, or your personal preference is for a looser fit, scale the print by 10%.
• I recommend printing with a brim to help with the adhesion.