Feet for the XTool D1. There are others out there, but I prefer mine because they are self-centering and easily allow you to tilt your machine to add leg extensions. When using these feet, do not use the rubber pads that come on the bottom of the D1 legs.

For placement, I recommend using some thing double sided tape on the bottom, as it's not possible to screw the feet in while the printer is on them. Apply tape, remove backing, tilt laser, place foot, lower laser and press down. It'll hold enough to mount with #6x3/4" screws.

Voron

No

No

.1-.2mm

40%

I printed mine in ABS at .2mm LH, 4 perimeters, 40% grid infill, 5 tops/bottoms.