This is a BL/3D/CR Touch mount that is shorter than normal to better fit in cases where the hotend is shorter than usual. This raises the touch sensor higher than with the mounts that come with the 3D Touch. It's made to fit the Creativity Direct Drive Titan Extruder hotend kit. However, you can probably use it on any Creality style X-gantry plate. You will likely only be able to mount this to the plate with only one screw, so use a washer. I also put some black electrical tape on the plate to give it more grip, but it's probably fine without it.

Fusion 360 file included if you want to make changes.

Voxelab Aquila X2

Doesn't Matter

No

0.20mm