THIS IS CREATED FROM "SAVE PANGOLINS" BY AMAOCHAN. The sections were fused together when I tried to print them, so this is the exact same file but with the pieces separated. You'll need to manually trim back the socket section of each piece in order to snap the ball joint in. Note: this file does not contain the feet, which can be found at the source below. Also see source for the order of assembly.

SOURCE: http://www.thingiverse.com/thing:2064359

SeeMeCNC

Rostock MAX v2

Yes

No

.2mm

10%

Trim back the socket section of each piece in order to snap the ball joint in- I used flush cutters. (This is necessary because it was designed to be print-in-place)