I was looking to raise one of the shelves in my detolf just a little bit to fit a 1/4 scale FREEing bunny figure in my case. I wanted something that would simply snap onto the existing metal bar, but nothing proper existed. Other solutions seemed to hang from the bar and looked like the would fail over time with any significant amount of weight on them. I found These 3d printed clips that replaced the little rubber sections the shelves came with and rested on and then modified them into a riser.

These will raise the glass shelf about 15 mm. I recommend using 6 of them. 3 on each side so the glass has support in the middle as well. I have printed these with 100 percent infill simply because I would rather error on the side of caution/strength. They don't use a lot of filament as it is.

AnkerMake

AnkerMake M5

No

No

100