I remixed this design to make it suitable for hanging it on every door and window. Now drilling is not needed anymore and you can hang this clothes hanger in your room or bathroom, wherever it is necessary. I printed it the same as you would hang it. So the bottom flat on your print bed is the long sloped side. You need supports and infill of at least 30% to make it stable.

Please check the thickness of your top door-edge to hang this on. For most room-doors or plastic window-frames it is mostly 15mm, but I made now also a version for 20mm and 36mm.

NEW in 2021: There are now three versions: for 15mm, 20mm and 36mm thick door-edges.

(update on 24.11.2018: please take a look at a new version on................ https://www.thingiverse.com/thing:3236572)

Anet A8

No

Yes

0.28

30%