Heyho, this is my Waveshare RP2040 Zero (Raspberry Pi Pico) sliding Case. I designed it for multiple days straight and this is how it turned out. The Board doesnt wobble around in there and there are little standoffs, so it doesnt do anything to the little pieaces onboard. The Upper part easily slides over the Bottom Part but still will be secure because of the "Rails" on their sides.

I have printed it in 0.12mm, 0.2mm does work good too but you should not go over 0.25mm.

Another cool thing, if you have a glass build plate, both sides will be clean and you dont even need Support or Rafts for both of the Parts.

I hope you like my Idea and how it turned out. Have fun with Printing it :)

For those who may ask: Why no buttons???

There also have been a version with button cutouts and little 3D printed Buttons, but it turned out that it could brake your Picos... While sliding in the upper part, the buttons can brake into pieces, so for your safety i will not upload that version.

Creality Ender 2 Pro

No

No

0.12 in my Case. Just dont go over 0.25

20% or Higher

Print both parts on their flat side.