A yarn bowl made in OpenSCAD. Designed to be practical. Includes receptacles for crochet hooks and scissors. Also includes a "foot" to reduce tipping and sliding.

Creality

Ender 3 Pro

No

Yes

0.2mm layer height

20%

I used standard Cura supports. The only place that has sufficient overhang is inside the holes in the sides of the bowl. The supports popped out cleanly with a little force.

It couldn't hurt to sand just a little bit on the inside of the holes after popping out the supports. Just to prevent yarn from snagging on any sharp bits left from where the supports previously attached.