Mount the Ulticontroller lower. No drilling is required. Also prevents Ulticontroller from being dislodged from Ultimaker when inserting and removing SD card.

I intend on making a chamber for the Ultimaker and the controller would normally be in the way of a front door.

This bracket does not allow the controller to rest on the table, changes to the scad file could allow for this if you want.

Requires two 3mm x 16mm screws.
Insert small piece behind wood and into the "U" and "r" letter slots.
Bolt screw through large piece and wood then into small piece.
Ensure that large piece bottom lip is pushed against bottom of wood base.