Summary

This simple bracket allows you to mount the "Full Graphic Smart LCD Controller" box found here: http://www.thingiverse.com/thing:87250 to the side of your makergear M2 frame.

Make sure you print the "Bottom_Case_FGD-_pockets" version of the case - it has very handy M3 nut patterns built into the bottom, they are all covered by 1 layer of plastic which you just punch out on the necessary holes, very good idea on their part!

You may need to also move the electronics box out to the right side of your printer, which I recommend doing for other reasons anyway.

By - http://www.easybotics.com/
And - http://hilo90mhz.com/