The wife bought these cheap 1 gallon drink dispensers for an upcoming party at WalMart for $5 each, but they did not come with a stand or base so that you can't get a cup under them (unless they're on the edge of a table). I designed these in tinkercad and printed up a couple. Holds the dispenser up high enough to fit a solo cup under and pour a drink. It also is printed in 2 parts where the top part (the tray) has a lip on the bottom to snugly fit over the base so it doesn't slide off and it also has a lip around the top to hold on to the the dispenser to keep that from sliding off the side.

This object was made in Tinkercad. Edit it online https://www.tinkercad.com/things/08xIXpYijyF

Bambulabs

Bambu P1S

No

Yes

.2

15%

supports are only required on the tray part because of the super long bridging that would be required for the lip that slides over the base. Print the base part with the top face down and no supports are required for that part.

The internal width of the tray is 167mm, which is the width of the widest part of the dispenser