This is a display stand that can be used for any 2 inch cube. Currently, I am use the display to hole the Screwless Cube Gears (http://www.thingiverse.com/thing:10483). I also plan on using this stand to display a Companion Cube (http://www.thingiverse.com/thing:13588). The stand holds the cube using a point contact on two of the cubes vertices. This allows the cube to spin freely. The fit of the Top Guide on the cube can be adjusted using the M3 screw in the base.

Required Parts:
1x M3x20mm screw and hex nut

RepRap

MakerFarm i3V 10

Doesn't Matter

Doesn't Matter

0.25mm or less

20-25%

Total print time for both the Base and TopGuide should be approximately 2 hours.