This is a bed leveling for Anycubic Kossel Plus, for a bed with 240mm diameter. I tried to minimized space for xploit all vertical interval.

Thread is M10x1, i tried M10x0.7 and is possible, but give some problems sometimes and doesnt present a clear advantage. And it is prepared for use DIN-7380 M4 screws.

There are two nut, lower is narrow for make more space and also have mark each 1/4 turn to have better leveling control, superior one is a little bit gross for better press

For a 240mm cristal bed Kossel you need to change reference points to; (-90,0,0), (45-78,0) and (45,78,0).

New version of base added, with less extrude length, 12mm are not necessary at all, I went down it to 8.

Anycubis Kossel Plus

No

0.1

12