Super Dungeon Explorer board game uses lots of these little cardboard coin-shaped tokens, so I built a holder for 18 sets of them.

Also included the Sketchup file and component so you can tweak or remix.

Zortrax M200

Yes

No

.19mm

"Full"

The uprights broke consistently while printing on my old un-lamented Solidoodle SD4, so I set infill to "Full", which is the maximum, (though not 100%), to make it stronger. This resulted in an 11-hour print, so I'd probably back off on the infill to speed thing up if I were to print it again.

Also it's a little more snug on the Zortrax printer, but still works fine. I might open up the Hole offset (or print the whole thing a little bigger). You probably want to print the component and check for fit before firing off the big piece.