Stencil for the ASU Sun Devils Pitchfork logo.

Two print thickness, .4 mm (.016") and .8 mm (.032"). The thinner part is flexible. The thicker part allows paint to flow under the supports a little better, as seen in the pictures.

Overall Height: ~4" (scale x and y to desired size)

I taped paper to the sides to prevent over spray. You can also add an extra piece of tape under the paper to stick to part, but it's not necessary. Don't spray too much paint or it will seep under the stencil and blur the image.

Printrbot

Printrbot Simple Metal

No

No

.2 mm

N/A

The thicker part might warp a little, so make sure to get good platform adhesion.

I put a dot of Elmer's glue over any gaps in the print. I did it on the top layer, since it only needs to block the hole.