A very simple Raspberry Pi 2 / 3 Enclosure. It uses 4 screws with countersinks in the bottom plate. This is about as simple as you can get for a full Pi enclosure.

Screws should be M2.5 to match the mounting holes for the board, or #2's should work as well.

Parts have been printed and test fitted against multiple Pi2 boards. Recommended print settings with PLA: .2mm height, 100% infill, no raft, no supports. If your printer is pretty well dialed in, you shouldn't need supports for the short overhangs. Part is designed to lose 1-3 layers and still fit well.

Providing the original 3DM source file, so feel free to adapt to your needs.

Rigidbot Big

No

No

.2mm

100%