Having printed, remixed and liked barneyj's 3DR Radio Case (air) [http://www.thingiverse.com/thing:40483, http://www.thingiverse.com/thing:712588] I've again scaled barneyj's case up and used it for another RC vehicle electronic pcb. This version of this great case is approximately 60mm X 32mm and has wire exit/entrance holes out both ends and one single mounting hole in the bottom.

Note: The color aluminum foil in the picture is EMI/RF protection/shielding.

• Print the box halves.
• Trim if neccessary.
  *. Install electronics.
• Snap halves together.
• Thank barneyj @ http://www.thingiverse.com/thing:40483