I designed this to help me be more organized. It works well, but the first version broke while my guitar was in the mount. The reason for this failure was that I didn't print it sideways, which would have given it more strength. You can also mess with the infill of the layers. I personally did 50% infill to be on the safe side, but you can easily go to something lower, like 30% or 40%. The mount currently only works for electric guitars, but if you want an acoustic guitar, just message me, and I will give it to you. The desk I have is made out of oak, so it was able to hold the mount; other woods like pine or pressed woods probably won't work. If there is any other information you would like to know, just message me.

*I have to print files because in v5 the PLA tabs holding the guitar began to push outward, so I had to make it stronger

*Make sure you print it sideways like in the photo because this give the mount the most strenght