This is a remix of the original Rabbit model by the original designer:
https://www.thingiverse.com/thing:3243450

I modified the model by cutting it into a flat version to turn it into a refrigerator magnet.

On the back, I added three magnet holes designed for round magnets with a diameter of 3 mm and a height of 2 mm. Each hole is 3 mm in diameter and 4 mm deep, allowing two magnets to be stacked in each hole for a stronger hold.

If your magnets fit a little too tightly or too loosely, you can easily adjust the overall scale of the model in your slicer to compensate for manufacturing tolerances.

Enjoy!