A sleeker looking BLTouch mount for the Ender 3 V2. Mounts the BLTouch forward and provides a shell to highlight the LED.

NOW WITH 3 CONFIGURATIONS!*
1) Screw on configuration if you have the printer head with mounting screw holes.
2) No-Screw configuration that clamps onto the printer head and only reuses the screw for the hotend cover
3) Wheel-screw configuration that has 1 less component than the No-Screw, bu requires the use of the V-Wheel screw.

*Shell is the same for each configuration.

OR

Just use the shell and mount to any mount you desire.

Probe offsets are as follows:
X: -45mm
Y: -10mm
Z: -1.60mm -> Based on my printer. WARNING: Z offset may be different for you. Please check you configuration after installing this mount for your z-offset. https://marlinfw.org/docs/gcode/M851.html

I can make modifications to the mount. If you need a variation of this assembly for your specific sensor, just reach out and let me know.

Useful links regarding the BLTouch:
BLTouch Documentation: https://www.antclabs.com/bltouch-v3
Marlin Firmware (now configurable for Ender 3 V2): https://marlinfw.org/
Already configured firmware: https://marlin.crc.id.au/
Creality Firmware: https://www.creality.com/download/32

BLTouch install instructions for Ender 3 V2: https://clicktime.symantec.com/34KkbksebxDoeCs1CNk4Kiu6H2?u=https%3A%2F%2Fwww.reddit.com%2Fr%2Fender3v2%2Fcomments%2Fi852fw%2Fender_3_v2_bltouch_v31_installation%2F