This is specifically for the Oculus branded USB C cable. When connected to the top C port on my Meshify 2 case, the wobble it has makes the whole thing sketchy AF for extended use. So I made this.

It eliminates the wobble and the odds of the cable connector breaking off if extra tension is applied. It's not too secured as not to damage the cable either. The whole thing just pops off instead. Important as the oculus cable uses fiber optics and not just plain wires.

Note that the hole sizing (14.1x8.2 mm) is for the official oculus cable connector and is a snug fit (might scratch the connector a little bit). Other cables will require resizing.
Outer dimensions (30x20 mm) are to clear the audio jack and power button on a Meshify 2. Should work with most other cases with horizontal aligned ports.

The part in the pics is supposed to be a draft model for testing but turned out decent enough for use. Printed with PETG-wood as that was on the printer at the time lol.
You can obviously print at better qualities but this should be minimum -

0.3 res
2 walls
10% Grid Infill

You'll need to excuse the obvious design flaw as this is my first time creating a 3D model and first time using TinkerCAD. ;)