A Borderlands 2 Theme Can Dice Roller.

I saw some of these on Instagram a few months ago but didn't like the design. Unfortunately I couldn't buy the STL to make edits so I remade it myself to add the design I wanted.

The biggest d20 I have tried with this has been 26mm wide at the widest point. The clearance between the ramps is ~30mm so it should fit dices up to that size.

27/02/2024 V2: Increased Can hole from 66.5mm to 67mm as can would fit but was very tight. Big dice (>25mm) would get stuck on the second ramp in the tower, so I increased the workplace height from 30mm to 37.5mm, and reduced the ramp length from 25mm to 17.5mm. I also decreased the height of the third ramp from 20mm to 15mm and decreased the length of the first ramp from 25mm to 20mm. Finally I added a lower ramp to the suspended first and second ramps so I wouldn't need to print the model with supports.

28/02/2024 V3: Increased dice exit height from 17mm to 20mm. Decreased hole in the bottom of can hole from 5mm to 3mm to keep the can in better. I did remove an area of infill to see if this would reduce filament use but it was the same as keeping the infill area in.