1/10 Scale ESC Holder
TheoSummers
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
0
0
게시일:2026-02-03 05:40:59
0
0
000설명
모델 소스
리뷰(0)
Summary
I wanted to mount an ESC that didn't have the Traxxas factory mounts for my Rustler 4x4. Unfortunately, I messed up a bit, making it too wide for the designated ESC spot. As a solution, I ended up placing it above the radio receiver box, affecting the body fit (it still fits, but poorly).
I used this ESC for the this, which I highly recommend for a budget brushless setup: https://www.amazon.com/Brushless-Waterproof-Electronic-Controller-RC/dp/B0CCY69JZ3
This mounting box should work for most ESCs around 40x50mm (height doesn't matter). Just ensure you secure it in the bottom with strong tape, like outdoor mounting tape.
If you want to modify it, the model only needs clearance for the support holding the watertight radio box and a small section of the internal honeycomb structure supporting the Rustler's side. I've attached a picture for reference.
Also I used some random screws I found to mount it in the car but the factory screws that hold down the stock ESC should work find, I just don't know where mine are.
Print Settings
Printer Brand:
Anycubic
<p class="detail-setting printer"><strong>Printer: </strong> <div><p>Vyper</p></div></p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>Doesn't Matter</p></div></p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div></p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.2</p></div></p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>20%</p></div></p> <strong>Filament:</strong> AnyCubic PLA Black <br> <p class="detail-setting notes"><strong>Notes: </strong> </p><div><p>Print however you like, its a very simple model. </p></div>모델 소스
원본 링크: 자세히 보기
CC BY-SA