Fully customizable T- or Y-junction gutter downspout, based on the original by fardog. The original had a locked 45 degree branch, which was too sharp of an angle to easily route my gutter into.

Claude was able to add an extra 'angle' parameter to the parametric SCAD file, so I am re-uploading as a remix to help anyone looking for this, as it's quite hard to find gutter junctions at hardware stores, especially for older style 2.5" square gutters like mine.

The included STL is for a 68mm x 68mm insert with a 20 degree branch. It will require supports (picture included) as the overhang is too extreme to print without them. I used painted on organic supports on the outside and inside of the branch mouth, and the waste was minimal.