Fully parametric plant support
Joanna Alfie
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
0
0
게시일:2026-04-11 19:35:05
0
0
000설명
태그
모델 소스
리뷰(0)
Support for plants around a circular base. Fully parametric (see the attached scad file), to print any size. Print upside down, no support needed whatsoever.
Scad file parameters:
| Parameter | Description | Default value | Unit |
|---|---|---|---|
| inner_diameter | Diameter between the feet - if your plant has some sort of circular base you want to put this support around of, this is the value you're after. This is also what defines the main diameter. | 56 | mm |
| hole_diameter | Diameter of the hole for the plant. Be mindful that depending on the angles below, the opening will most likely be smaller than that. | 5 | mm |
| ring_width | Width of the outer ring. | 11 | mm |
| supports | Number of supports. Less supports will mean a larger opening to the centre hole, as the angle of the opening is the angle between two supports. | 5 | n/a |
| support_angle | Angle each support occupies. Larger angle means larger supports. | 15 | Degrees |
| support_height | Height of the supports | 30 | mm |
태그
모델 소스
원본 링크: 자세히 보기
CC BY-SA