Project: FREEZER.hfp
Print at 100% infill with a layer height of 0.08 mm and a first layer of 0.16 mm

The model has a size of 200x112.53 mm

You can print with higher layer heights below the minimum depth of 0.48 mm (Note: this is to save time on the base, but if you use 0.16 mm for the first layer and 0.08 mm for the rest, it will come out perfect and without complications)

The maximum depth is 2.2 mm and the actual depth is 2.2 mm

Filaments used:

PLA jayo black (Transmission distance: 1.7)

PLA elegoo purple (Transmission distance: 2)

PLA eSUN pink (Transmission distance: 5)

PLA PolyLite white (Transmission distance: 5)
This print uses 4 unique filaments

Filament change instructions:

Start with black

At layer #9 (0.8 mm) change to purple

At layer #16 (1.36 mm) change to pink

At layer #20 (1.68 mm) change to white for the rest of the print

I PAINTED THE RED OF THE EYES WITH A RED "BIC PEN" SINCE I ONLY USED 4 FILAMENT COLORS