Yet Another Solder Holder :-)

The main advantage of this model is that it prints as a single piece - no assembly or additional printed parts required.

Both PLA and PETG work well, so the material choice is entirely up to you.

Compatible Spool Dimensions

• Maximum outer diameter: 63 mm
• Maximum spool width: 36 mm
• Minimum spool inner hole diameter: 20 mm

You can use spools with a smaller outer diameter or a narrower width. However, the inner hole must be at least 20 mm in diameter so that the spool fits onto the holder’s central pin.

I recommend attaching rubber feet or non-slip pads to the bottom of the holder. This will prevent it from sliding across the desk while you are soldering and pulling out the wire.

There are already plenty of solder holders out there—but perhaps this design will be useful to you or inspire you to create your own version!