“You'll Walk Through Walls!” -Gadget Gabe (2009)

This is the Henry Stickmin Opacinator device seen in the Henry Stickmin Series. This is V.1. Supports may be needed. If you appen to run into any print problems, feel free to comment and I will do my best to help. FREE TO SELL

Alignment divots are included to help line up parts.Each piece is printed separately, and uses PLA. The colors I used were PLA green, red, blue, and gray. Every piece will have to be glued, and some parts may need a bit of cleanup since they’re tight fits. 

Gluing instructions: When gluing, glue the red and green buttons on first, they will need cleanup since they have extremely tight fits. Next, glue the gray slider receiver on, and the small green tip. last, glue the blue slider on any desired spot on the slider receiver. Remember, a little glue goes along way! so put the smallest amount for the green tip.

This is my very first model, but definitely not my last! I might make a V.2 with clickable buttons, I’ll Just have to figure that out.