I made DJI 04 Air Unit Pro camera mounts for NewBeeDrone StingerBee HD frame that keep the Pro camera fully protected by the frame. I moved the camera as forward as possible while keeping clear from the standoffs.

You have to remove the standoff behind the camera and use my re-mixed GPS mount that moves the front top standoff backwards. 

If you have ELRS version like mine, you have to also get rid of the RX holder. I printed a TPU tie-down based on Fractal Engineering F75 design, but the RX kinda has to be showed behind the camera and barely fits there.

I also lifted the AIO slightly by using Silicon O-rings since the wires below the AIO seemed rather squished.

There is not much room to change the camera tilt, but feel free to tinker further. I made 4 prototypes to get the best clearance and may play with the camera angle some more. 

Printed in Polymaker PolyFlex TPU95, 100% infill, 3 walls. X1 Carbon.